How to Install a Standard Shower Door: Step-by-Step Guide

- Tape measure

- Level

- Drill with screwdriver bits

- Silicone sealant

- Caulking gun

- Hammer

- Shower door installation kit (including U-channel, clips, screws, and door parts)

- Rubber mallet

- Safety gloves and goggles

Before purchasing your shower door, it’s crucial to measure the width and height of your shower opening accurately. Measure at the top, middle, and bottom of the opening, and use the smallest width measurement. These precise measurements will help you choose the perfect shower door from our website that fits your space.

Tip: Always make sure to have the correct measurements in hand when selecting from our wide range of shower doors. Whether you need a door with a U-channel frame, clips, or a slider, buying from our website ensures that you get the right size for a smooth installation.

For U-channel frames:

- Cut the U-channel to fit the bottom and sides of your shower opening. Use a hacksaw for precise cuts.

- Apply silicone along the bottom and side edges where the U-channel will be installed.

- Place the U-channel on the shower base and walls, ensuring it's level. Secure with screws after drilling pilot holes.

For clips:

- Mark the positions where the clips will be installed along the bottom and sides. These should be spaced evenly.

- Drill pilot holes and insert anchors where needed. Secure the clips with screws.

- Use silicone sealant around the edges for waterproofing.

Step 3: Install the Fixed Glass Panel 

Carefully place the fixed glass panel into the U-channel or secure it using the clips. If you're using U-channel, slide the panel into place, ensuring it’s snug and level. If you're using clips, tighten the clips around the panel carefully without over-tightening.

For sliding doors:

- Install the rollers onto the top edge of the door panel. Place the door panel onto the track at the bottom and hang it onto the top rail.

- Ensure the door slides smoothly. Adjust the roller height if necessary.

For swing doors:

- Attach the hinges to the door panel and then secure them to the wall or fixed glass panel, depending on the design.

- Check that the door swings open and closes correctly. Adjust the alignment as needed.

Once the door is in place, apply a thin bead of silicone along the edges where the glass meets the walls and base to ensure a watertight seal. Allow the silicone to cure as directed on the sealant package.

Check that the door opens and closes smoothly. Wipe down the glass and metal parts to remove any fingerprints or debris.